One of the most consistent problems facing the Duct and Pipe designers that we come across here at Ideate, Inc. during support cases dealing with Duct or Pipe Calculations is “missing” end caps.
New functionality has been enabled that will add cap(s) on open ends of pipe and duct content. There are two methods in which this functionality can be used. The first method is to select pipe/duct content and then use the ribbon button “Cap Open Ends”. This method will add cap(s) to all open ends of the selected content. The second method is to right click on a pipe/duct connector and select “Cap Open End” from the popup menu. This method will cap the open end of the connector that was selected.
The routing preferences will be used in conjunction with the Cap On Open end functionality to determine which cap will be added to the open end of the pipe/duct content.
While this feature could probably be used for other reasons, it was built targeting the following use cases:
- Use with Pipe
- Use with Duct
- Use with both Duct and Pipe fittings
- Use with both Duct and Pipe accessories
Ideate Senior MEP Application Specialist
Bill has over 20 years experience in applying AEC design solutions for large commercial companies. A graduate of Pasadena Institute of Technology, he has worked for TEECOM Design Group, GTE/GTEL, Greg LeDoux and Associates, and Scottish Power in England. Bill has also had the opportunity to act as Lead AutoCAD Designer for multimillion dollar communication sites which have included structural, electrical, HVAC, conduit, cable plans and equipment layouts. He has a Sustainable Design Certification from the University of California at Berkeley.
Get it. Know it. Use it.
0 comments:
Post a Comment